@@ -166,6 +166,13 @@ parse_bitbake_line() {
eval $var=$val
}
+# Input is a line of the form LOCALCONF:.*=value
+parse_localconf_line() {
+ localconf=`echo "$1" | cut -d: -f2`
+ echo "$localconf" >> $oebase/tmp_append_local.conf
+}
+
+
# Input is a repository description line as detailed in the usage section
@@ -221,6 +228,11 @@ parse_repo_line() {
parse_input_file() {
+ if [ -e $oebase/tmp_append_local.conf ]
+ then
+ rm $oebase/tmp_append_local.conf
+ fi
+
while read line
do
# clean the parsing variables for each run
@@ -252,7 +264,7 @@ parse_input_file() {
continue
fi
- # If the line starts with OECORE then parse the OECORE setting
+ # If the line starts with BITBAKE then parse the BITBAKE setting
echo $line | grep -e "^BITBAKE.*=" > /dev/null
if [ "$?" = "0" ]
then
@@ -261,6 +273,14 @@ parse_input_file() {
continue
fi
+ # If the line starts with LOCALCONF: then parse the LOCALCONF: setting
+ echo $line | grep -e "^LOCALCONF:.*" > /dev/null
+ if [ "$?" = "0" ]
+ then
+ parse_localconf_line "$line"
+ output="$output""$line\n"
+ continue
+ fi
# Since the line is not a comment or an OECORE setting let's assume
# it is a repository information line and parse it
parse_repo_line $line
@@ -783,6 +803,21 @@ EOM
fi
sed -i "s|^DL_DIR.*|DL_DIR = \"${dldir}\"|" $confdir/local.conf
+
+ if [ -e $oebase/tmp_append_local.conf ]
+ then
+ echo "" >> $confdir/local.conf
+ echo "#====================================================================" >> $confdir/local.conf
+ echo "# LOCALCONF: settings from config file:" >> $confdir/local.conf
+ echo "# $inputfile" >> $confdir/local.conf
+ echo "#" >> $confdir/local.conf
+ echo "# Do not remove." >> $confdir/local.conf
+ echo "#--------------------------------------------------------------------" >> $confdir/local.conf
+ cat $oebase/tmp_append_local.conf >> $confdir/local.conf
+ echo "#====================================================================" >> $confdir/local.conf
+ echo "" >> $confdir/local.conf
+ rm $oebase/tmp_append_local.conf
+ fi
}
print_image_names() {
For some layersetup scenarios, it might be advantageous to allow for settings that should go into the local.conf file for a given set of layers. To that end, any line starting with LOCALCONF: will be appended to the end of the local.conf. Signed-off-by: Ryan Eatmon <reatmon@ti.com> --- oe-layertool-setup.sh | 37 ++++++++++++++++++++++++++++++++++++- 1 file changed, 36 insertions(+), 1 deletion(-)