@@ -37,6 +37,8 @@ SYSFW_PREFIX_am62xx-evm-k3r5 = "fs"
SYSFW_TISCI = "${S}/ti-sysfw/ti-${SYSFW_PREFIX}-firmware-${SYSFW_SOC}-*.bin"
+SYSFW_TIBOOT3 = "tiboot3-${SYSFW_SOC}-${SYSFW_SUFFIX}-${SYSFW_CONFIG}.bin"
+
SYSFW_BINARY = "sysfw-${SYSFW_SOC}-${SYSFW_CONFIG}.itb"
SYSFW_VBINARY = "sysfw-${PV}-${SYSFW_SOC}-${SYSFW_CONFIG}.itb"
SYSFW_IMAGE = "sysfw-${SYSFW_SOC}-${SYSFW_CONFIG}.itb"
@@ -78,10 +80,9 @@ do_install() {
fi
fi
- if [ -f "${WORKDIR}/imggen/${UBOOT_BINARY}" ]; then
- install -m 644 ${WORKDIR}/imggen/${UBOOT_BINARY} ${D}/boot/${UBOOT_IMAGE}
- ln -sf ${UBOOT_IMAGE} ${D}/boot/${UBOOT_SYMLINK}
- ln -sf ${UBOOT_IMAGE} ${D}/boot/${UBOOT_BINARY}
+ if [ -f "${WORKDIR}/imggen/${SYSFW_TIBOOT3}" ]; then
+ install -m 644 ${WORKDIR}/imggen/${SYSFW_TIBOOT3} ${D}/boot/${SYSFW_TIBOOT3}
+ ln -sf ${SYSFW_TIBOOT3} ${D}/boot/tiboot3.bin
fi
}
@@ -100,10 +101,9 @@ do_deploy () {
fi
fi
- if [ -f "${WORKDIR}/imggen/${UBOOT_BINARY}" ]; then
- install -m 644 ${WORKDIR}/imggen/${UBOOT_BINARY} ${DEPLOYDIR}/${UBOOT_IMAGE}
- ln -sf ${UBOOT_IMAGE} ${DEPLOYDIR}/${UBOOT_SYMLINK}
- ln -sf ${UBOOT_IMAGE} ${DEPLOYDIR}/${UBOOT_BINARY}
+ if [ -f "${WORKDIR}/imggen/${SYSFW_TIBOOT3}" ]; then
+ install -m 644 ${WORKDIR}/imggen/${SYSFW_TIBOOT3} ${DEPLOYDIR}/${SYSFW_TIBOOT3}
+ ln -sf ${SYSFW_TIBOOT3} ${DEPLOYDIR}/tiboot3.bin
fi
install -m 644 ${SYSFW_TISCI} ${DEPLOYDIR}/
Currently we reuse UBOOT_* names which usually are the same we want to give to the name of the SYSFW binary. This isn't always correct, we should use a SYSFW specific variable in case the UBOOT names are changed. Signed-off-by: Andrew Davis <afd@ti.com> --- recipes-bsp/ti-sci-fw/ti-sci-fw_git.bb | 16 ++++++++-------- 1 file changed, 8 insertions(+), 8 deletions(-)