@@ -1482,12 +1482,11 @@ relocatable SDK used to develop applications. When you run the
installer, it installs the toolchain, which contains the development
tools (e.g., ``gcc-cross-canadian``, ``binutils-cross-canadian``, and
other ``nativesdk-*`` tools), which are tools native to the SDK (i.e.
-native to :term:`SDK_ARCH`), you
-need to cross-compile and test your software. The figure shows the
-commands you use to easily build out this toolchain. This
-cross-development toolchain is built to execute on the
-:term:`SDKMACHINE`, which might or
-might not be the same machine as the Build Host.
+native to :term:`SDK_ARCH`), you need to cross-compile and test your
+software. The figure shows the commands you use to easily build out
+this toolchain. This cross-development toolchain is built to execute on the
+:term:`SDKMACHINE`, which might or might not be the same machine as
+the Build Host.
.. note::
@@ -132,22 +132,21 @@ build the SDK installer. Follow these steps:
5. *Make Sure Your SDK Machine is Correctly Set:* If you are building a
toolchain designed to run on an architecture that differs from your
current development host machine (i.e. the build host), be sure that
- the :term:`SDKMACHINE` variable
- in the ``local.conf`` file in your Build Directory is correctly set.
+ the :term:`SDKMACHINE` variable in the ``local.conf`` file in your
+ Build Directory is correctly set.
.. note::
If you are building an SDK installer for the Extensible SDK, the
- SDKMACHINE
- value must be set for the architecture of the machine you are
- using to build the installer. If
- SDKMACHINE
+ :term:`SDKMACHINE` value must be set for the architecture of the
+ machine you are using to build the installer. If :term:`SDKMACHINE`
is not set appropriately, the build fails and provides an error
message similar to the following::
- The extensible SDK can currently only be built for the same architecture as the machine being built on - SDK_ARCH is
- set to i686 (likely via setting SDKMACHINE) which is different from the architecture of the build machine (x86_64).
- Unable to continue.
+ The extensible SDK can currently only be built for the same
+ architecture as the machine being built on --- :term:`SDK_ARCH`
+ is set to ``i686`` (likely via setting :term:`SDKMACHINE`) which is
+ different from the architecture of the build machine (``x86_64``).
6. *Build the SDK Installer:* To build the SDK installer for a standard
@@ -56,7 +56,7 @@ the "templates" section, which looks like::
Combining these two entries you can see that "qemux86-64" is a three step build where the
``bitbake BBTARGETS`` would be run, then ``bitbake SANITYTARGETS`` for each step; all for
-``MACHINE="qemux86-64"`` but with differing SDKMACHINE settings. In step
+``MACHINE="qemux86-64"`` but with differing :term:`SDKMACHINE` settings. In step
1 an extra variable is added to the ``auto.conf`` file to enable wic
image generation.